This course provides an introduction to the analysis and design of digital systems and microprocessors. Review of combinational logic analysis and design. Systematic design methods. Analysis and design of synchronous sequential machines. Computer aided design and programming of digital electronic circuits using VHDL hardware description language and FPGA programmable logic devices. Microprocessor and microcomputer architecture. Microprocessor devices, their architecture and instruction sets. Hardware aspects of instruction execution. Assembler and C programming. Input/output, bus interfacing, interrupts. Co-design of digital hardware and microprocessor systems.
Learning Outcomes
Upon successful completion, students will have the knowledge and skills to:
Course Outcomes:
- Use top-down design to translate system requirements into a practical digital design.
- Design complex digital systems through finite state machines and the register transfer level technique and implement these in programmable logic.
- Learn fixed point DSP.
- Learn how to program in C and VERILOG HDL.
- Learn to use ISE WebPACK to realise complex digital designs in FPGAs.
- Learn about and use free and open source design software.
- Learn practical electronics testbench skills and the ability to communicate appropriately via a lab notebook.
- Learn to build and use microprocessors
Indicative Assessment
Assessment (10%); Midterm Exam (20%); Labs (30%); Exam and Project (40%)
The ANU uses Turnitin to enhance student citation and referencing techniques, and to assess assignment submissions as a component of the University's approach to managing Academic Integrity. While the use of Turnitin is not mandatory, the ANU highly recommends Turnitin is used by both teaching staff and students. For additional information regarding Turnitin please visit the ANU Online website.
Workload
Twenty one lectures plus three hours of labs per week
Requisite and Incompatibility
Prescribed Texts
Reading Material
- Text book - John F Wakerly (Digital Design, Principles and Practices, Prentice Hall) - available now in the book shop.
- There is a reading brick from 2008.
There are a number of other texts:
- Vahid and Lysecky (Verilog for Digital Design, Wiley): good for RTL verilog.
- Milos Ercegovac (Introduction to Digital Systems, Wiley. Chs 13-15) good for RTL design but all in VHDL and
- Furber (ARM SoC Architecture, Addison-Wesley): background reading for later on in the course.
Assumed Knowledge
Assumed knowledge in the area of electronics and communications
Fees
Tuition fees are for the academic year indicated at the top of the page.
If you are a domestic graduate coursework or international student you will be required to pay tuition fees. Students continuing in their current program of study will have their tuition fees indexed annually from the year in which you commenced your program. Further information for domestic and international students about tuition and other fees can be found at Fees.
- Student Contribution Band:
- 2
- Unit value:
- 6 units
If you are an undergraduate student and have been offered a Commonwealth supported place, your fees are set by the Australian Government for each course. At ANU 1 EFTSL is 48 units (normally 8 x 6-unit courses). You can find your student contribution amount for each course at Fees. Where there is a unit range displayed for this course, not all unit options below may be available.
| Units | EFTSL |
|---|---|
| 6.00 | 0.12500 |
Course fees
- Domestic fee paying students
| Year | Fee | Description |
|---|---|---|
| 1994-2003 | $2088 | |
| 2014 | $2952 | |
| 2013 | $2946 | |
| 2012 | $2946 | |
| 2011 | $2946 | |
| 2010 | $2916 | |
| 2009 | $2916 | |
| 2008 | $2190 | |
| 2007 | $2088 | |
| 2006 | $2088 | |
| 2005 | $2088 | |
| 2004 | $2088 |
- International fee paying students
| Year | Fee |
|---|---|
| 1994-2003 | $3450 |
| 2014 | $3762 |
| 2013 | $3756 |
| 2012 | $3756 |
| 2011 | $3756 |
| 2010 | $3750 |
| 2009 | $3750 |
| 2008 | $3618 |
| 2007 | $3618 |
| 2006 | $3618 |
| 2005 | $3534 |
| 2004 | $3450 |
Offerings, Dates and Class Summary Links
ANU utilises MyTimetable to enable students to view the timetable for their enrolled courses, browse, then self-allocate to small teaching activities / tutorials so they can better plan their time. Find out more on the Timetable webpage.
Class summaries, if available, can be accessed by clicking on the View link for the relevant class number.
First Semester
| Class number | Class start date | Last day to enrol | Census date | Class end date | Mode Of Delivery | Class Summary |
|---|---|---|---|---|---|---|
| 3903 | 17 Feb 2014 | 07 Mar 2014 | 31 Mar 2014 | 30 May 2014 | In Person | N/A |